What Master’s Mix is
Master’s Mix is a popular fruiting substrate made from hardwood sawdust supplemented with soy hulls. It is widely used by home growers and small farms. The soy hulls add nitrogen and other nutrients that plain sawdust lacks, which can support bigger harvests. Because it is so nutritious, it is also a very inviting food for contaminants, so it is sterilized rather than pasteurized.
Different growers use slightly different versions, so treat the figures below as a common starting point and adjust to your species and supplier.
Ingredients and ratio
The classic version uses roughly equal parts, by volume, of two ingredients:
- Hardwood sawdust (or hardwood fuel pellets, which expand into sawdust when wet). Choose sawdust from a suitable hardwood such as oak, maple or beech, and avoid sawdust from treated wood or from woods that are poor choices for mushrooms. Species-specific advice varies.
- Soy hulls (the outer coat of the soybean, usually sold as animal feed). Make sure they are clean and free of mold.
A 50/50 volume ratio is common, though some growers shift to roughly 60 to 70 percent sawdust or add a small amount of gypsum. Weighing ingredients, rather than relying on volume, gives more repeatable results.
Hydrating
Moisture is critical. The mix should be damp enough to hold together but should not drip when squeezed. This is often described as “field capacity,” and a figure of around 60 percent moisture by weight is commonly quoted. A squeeze test helps: a firm handful should leave your hand damp and release only a drop or two. Pellets need time to break down into sawdust after you add hot water, so stir them thoroughly and allow the water to soak in evenly. Mix the soy hulls through at the same time.
A mix that is too wet can encourage bacteria, and one that is too dry slows colonization. See what helps mycelium grow faster for related moisture tips.
Bagging and sterilizing
Pack the mix loosely but evenly into polypropylene grow bags with filter patches. Pressure sterilization is generally recommended for this mix. A commonly cited figure is about 15 psi for roughly two to two and a half hours, though some growers use up to three hours for large bags, and it depends on the size of the load and your equipment. For more detail on timing and safe use of the cooker, see how long to pressure cook mushroom substrate and grain jars.
Allow the bags to cool completely before opening, since inoculating hot substrate can kill the mycelium and draw contaminants in as the bag cools.
Inoculating and incubating
In clean air, such as a still air box or flow hood, mix in grain spawn. A common range is around 5 to 10 percent or more of the substrate’s weight, with higher rates giving faster colonization and a lower contamination risk. Seal the bag and incubate in a warm, dark place. Many species colonize in a few weeks. The block is ready to fruit when the mycelium covers the material and may have started forming a skin or small pins. For spawn basics, see mushroom spawn explained.
Fruiting
Open the bag or cut slits, then provide humidity, fresh air and appropriate light for your species. Specific temperature, humidity and timing depend on the mushroom, so follow guidance for the species you are growing.
Species it suits
Supplemented sawdust is commonly used for oyster mushrooms, lion’s mane, shiitake and other wood-loving gourmet species. Oysters are usually the most forgiving. For some species, a fully supplemented mix may be too rich or may suit a different ratio. For comparison with other materials, see the best substrate for mushroom cultivation.
Troubleshooting
- Contamination in many bags. Inadequate sterilization time, overfilled cookers or poor cooling and inoculation hygiene are the usual suspects.
- Slow colonization. Check temperature, moisture and the quality and quantity of spawn.
- Soggy bottoms. The mix may have been too wet or packed too tightly.
- Poor fruiting. Check humidity, air exchange and whether the block is fully colonized. See why mushrooms won’t pin.